Indmar Marine Formed 1" 90° Hose | Part #841033
Maintain leak-free cooling System flow with this genuine Indmar 1 inch 90-degree formed hose. Pre-formed to the exact OEM shape, this hose fits perfectly first time — no bending, kinking, or makeshift modifications needed. Purpose-built for Indmar marine engines where precise hose routing in tight engine bays is critical.
Compatible with: Indmar marine engines fitted to Malibu, Moomba, Supra, and Tige boats.
Why use a formed hose over a straight hose?
A pre-formed 90-degree hose holds its shape permanently — unlike a straight hose bent into position which can kink over time, restricting coolant flow and causing overheating. The formed shape also reduces stress on the hose connections, meaning fewer leaks and longer service life.
When should you replace it?
Inspect your hoses every season. Replace immediately if you notice:
- Cracking or splitting along the hose body
- Swelling or soft spots
- Coolant weeping at the hose ends
- Hose hardening or loss of flexibility
A failed hose on the water means no cooling — and that means a very expensive engine repair.
Pairs perfectly with:
- 845040 – Hose J-Formed with Spring
- 866081 – Thermostat Housing Aluminium Full F/W
- 986034 – Thermostat 160° Drilled LT1 & 5.7L F/W
- 985006 – Thermostat Housing Gasket
- 531069E – Thermostat Housing Lower Low Profile E-Coat
Features:
- Genuine Indmar OEM part
- Pre-formed 90° shape — no kinking or collapsing
- 1" diameter — OEM spec fitment
- Heat and coolant resistant rubber construction
- Direct replacement — no modifications needed
Part Number: 841033
In stock and shipped fast from Australia 🇦🇺
